WYSE 55 TERMINAL SETTINGS
To enter setup mode press [SHIFT][SELECT]
Make sure the cable is plugged in the MODEM port.
Press [F1] and check the
following:
| Columns | =Econ-80 | Cursor | =Blink Blk | Scrn Saver | =On |
| Lines | =25 | Display | =Dark | Char Cell | =10 x 15 |
| Page Length | =1 x Lines | Autopage | =Off | 80/132 CLR | =Off |
Press [F2] and check the
following:
| Personality | =Wyse 120+ | Enhance | =On | Status Line | =On |
| Scrl | =Jump | Autoscrl | =On | Wrap EOL | =On |
| Rvc CR | =CR | Monitor | =Off | Recognise Del | =Off |
Press [F3] and check the following:
| Keyclick | =On | Repeat | =On | Keycode | =ASCII |
| Keylock | =Caps | Language | =UK | Corner Key | =Funct |
| Codepg | =PC Wyse ASCII | ASCII Font | =Wy ASCII | ASCII | =National 7 Bit |
Press [F4] and set the
following:
| COMM | =FDX | XMT Lim | =None | Answerback | =Off |
| MDM RC HSK | =Xon/Xoff | MDM RC HSL Level | =192 | MDM XMT HSK | =None |
| AUX RC HSK | =None | Send ACK | =On | Aux XMT HSK | =None |
Press [F5] and set the
following:
| MDM Baud Rate | =19200 * | MDM Data/Parity | =8/NONE | MDM Stop Bits | =1 |
| AUX Baud Rate | =19200 | AUX Data/Parity | =8/NONE | AUX Stop Bits | =1 |
| Host Port | =Modem Port | Printer Attached | =On | Nulls Suppress | =On |
[F6]= (Should not need to be changed)
[F7]= (Should not need to be changed)
[F8]= (Should not need to be changed)
Press [F9] and press the [BACKSPACE] key to set the defaults.
[F10]= (Should not need to be changed)
[F11]= (Should not need to be changed)
To save: tap [F12], tap the spacebar once, tap [F12] again
If you need to alter the setting frequently, you should contact your hardware company as it indicates either the internal battery is getting low or there is a fault in the terminal.